7435A REV C Norge Dryer Parts List

Search the entire 7435A REV C by part description. Keep descriptions simple, e.g. "belt" or "pump". Need help?

Wash arm bearing ring

This part will fit between the newer type lower wash arm and the wash arm retainer nut of your dishwasher.

Easy Part #:: EAP11747064

Availability:: In Stock

Price:: $37.67

Grease filter (filter, grease)

The grease filter is intended for use with some downdraft cooktops and ranges to collect grease particles in the air from cooking. The grease filter is silver in color, approximately 15 1/2” long and almost 6 1/4” wide. As per the manufacturer, the original filter may have been a 1/2” wider, but it should not be a problem and will still function the same. The grease filter is sold individually and is a genuine OEM part.

Easy Part #:: EAP11743870

Availability:: In Stock

Price:: $35.27

Friction sleeve (pad)

The friction sleeve helps to reduce friction between the door hinge and the door and to keep your door quiet when it opens and closes. This part is a little over an inch long and is black in color. It is sold individually.

Easy Part #:: EAP11745488

Availability:: In Stock

Price:: $8.61

Washing machine suspension rod kit (use wpl w10349191)

Easy Part #:: EAP11703290

Availability:: In Stock

Price:: $87.59

Front drum bearing (top bearing)

The drum support bearing helps your dryer operate as quietly as possible by allowing the front of the drum to glide smoothly on the felt seal of the front panel when the drum is rotating. If your dryer is noisy or making a squeaking sound, the slides are probably worn and both slides will need to be replaced. This part measures 10” in height and 19 ½” inside width. Four drum glides are used with the drum support bearing and are sold separately. The support bearing is a genuine OEM part. Please remember to disconnect the power to the dryer before starting your repair.

Easy Part #:: EAP960316

Availability:: Special Order

Price:: $34.33

Crisper support - rear (shelf support stud)

This rear crisper cover support mounts to the inside of the cabinet wall to support the rear crisper cover. The support is held in place by a locking pin. If your shelf is not level or the drawer is not opening and closing properly, you may need to replace this part. This is a genuine OEM part and is sold individually.

Easy Part #:: EAP2358879

Availability:: In Stock

Price:: $14.60

Dishwasher inlet valve (valve-inlt)

This water inlet valve should be located behind the lower kick plate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of water needed.

Easy Part #:: EAP12578165

Availability:: In Stock

Price:: $73.57

Drain pump - 60hz 120v (drain pump and motor assembly)

This pump helps expel water from the washing machine and is activated after the spin speed is maintained for a specific period of time.

Easy Part #:: EAP2342445

Availability:: In Stock

Price:: $187.67

High limit thermostat and thermal cut-off kit

Also known as Thermal Cut-Off kit. The thermostat acts as a safety mechanism that keeps the dryer from overheating and the fuse is like a backup system - it's set to trip at a higher temperature than the thermostat. Once it trips, it has to be replaced.

Easy Part #:: EAP334387

Availability:: In Stock

Price:: $61.22

Bi-metal fuse (thermal electronic fuse)

This part is used as a safety device to protect the dishwasher circuit from overload. If the temperature gets to high it will shut off the electrical current to the heating unit in the appliance. Also known as Thermal Fuse.

Easy Part #:: EAP2360984

Availability:: In Stock

Price:: $39.70

Timer knob

This knob accepts a D-shaped shaft.

Easy Part #:: EAP418921

Availability:: In Stock

Price:: $67.85

Refrigerator water filter - white (filter assembly, puresource u-ii, w/cap)

Easy Part #:: EAP11704498

Availability:: In Stock

Price:: $94.66

Dryer cycling thermostat (cycling thermostat (limit: 155-25))

The cycling thermostat with an internal bias heater will continually cycle the heating element off and on to maintain a constant inner temperature in the dryer. This cycling thermostat has a limit of 155 degrees Fahrenheit and a differential of 25 degrees. Meaning that the heating element will cut out at 155 degrees and cycle back on once the internal temperature drops by 25 degrees. This is a genuine OEM part. Please remember to disconnect the power to the dryer before starting the repair.

Easy Part #:: EAP11741405

Availability:: In Stock

Price:: $32.14

Lid switch (switch)

This is a replacement lid switch for your washer. The pin on the lid pushes on the lever of the lid switch to tell the machine that the lid is closed.

Easy Part #:: EAP11722098

Availability:: In Stock

Price:: $60.75

Idler pulley with bracket (bracket)

The idler pulley wheel is now sold with this arm. This idler pulley is for dryers. Idler pulley maintains correct tension on the drive belt to spin the drum.